To have the flexibilty in application; to use any of the section
(data/bss/heap) without updating linker script in every use case,
following decisions are made:
1. Fixed size and small sections moved to SRAM2 (32K)
Vectors
Crash data
Remaining section - RW / ZI
2. Large memory space should be used for variable sections
RW/ZI
Heap - (Minimum - 0x12000)
Stack - At bottom
Please note the heap address of the both the banks must not be contigious else
GCC considers it to be single memory bank and does allocation across the banks,
which might result into hard-fault
To have the flexibilty in application; to use any of the section
(data/bss/heap) without updating linker script in every use case,
following decisions are made:
1. Fixed size and small sections moved to SRAM2 (32K)
Vectors
Crash data
Stack
Remaining section - Heap memory
2. Large memory space should be used for variable sections
Data
BSS
Heap - Remaining section
Heap is moved to the end of both sections as GCC allocates till 4K boundary,
if end of heap is not aligned to 4K, that chunk of memory will go unutilized
Internal channels use is enabling ADC "internal path" which needs
to be disabled after measurement.
Same applied here for WB family as was done for others in #10143.
Typically the RTC clock is configured by RTC driver itself.
RNG on the other hand is shared with M0+ core and it is expected that
M4 turns it on at boot time.
When doing so, do not disbale GPIO clocks as they may be used by other
drivers !
As a result, debug will be disabled by default, but can be enabled by
either modifying code or selecting MBED debug profile.
Review HSE clock initialization to match with latest CUBE firmware.
Also there is no need to set the full clock tree again after deep sleep exit.
With this change we get a stable deep sleep mode (when allowed by CORDIO stack).
There is no need to add FIRST attribute to MAPPING_TABLE as the default
ordering is alphabetical order.
With this change, we don't have any warning with MBED2 and the sections
are properly ordered anyway in BLE cases.
In case of mbed2, BLE feature is not built.
As there is a MAPPING_TABLE in BLE feature which is not compiled in case
of mbed2, the linker reported the below error
[ERROR] "C:/Data/Workspace/mbed/BUILD/test/NUCLEO_WB55RG/ARM/MBED_2/
.link_script.sct", line 65 (column 6): Error: L6236E:
No section matches selector - no section to be FIRST/LAST.
Solution is to check whether BLE is enabled.
These files are not BLE specific, but also needed for some clock setting
for instance.
In order to compile an MBED2 application, we need to move the files.
- move hw_conf.h file to targets/TARGET_STM/TARGET_STM32WB directory as
this is used also out of BLE feature.
- create a dedicated hal_deepsleep function as the behavior in WB is a lot
different from other existing STM32 targets
- update clock tree configuration to directly clock the entire tree @ 32MHz
out of HSE. This is needed as we want to let the M0 core running without
any change on M0-side of clocks when M4 enters /exits deep sleep.
Martin Kojtal
Malavika Sajikumar
Anna Bridge
Juho Eskeli
Deepika
jeromecoutant
Marcus Chang
Vincent Veron
Cruz Monrreal
Ashok Rao
Laurent Meunier
bcostm