3.0 KiB
| layout | title |
|---|---|
| documentation | 50x4xx - ZWave |
{% include base.html %}
50x4xx Switch Sensor Cover
This describes the Z-Wave device 50x4xx, manufactured by Merten with the thing type UID of merten_50x4xx_00_000.
The device is in the category of Wall Switch, defining Any device attached to the wall that controls a binary status of something, for ex. a light switch.
The 50x4xx supports routing. This allows the device to communicate using other routing enabled devices as intermediate routers. This device is also able to participate in the routing of data between other devices in the mesh network.
Overview
The sensor cover contains a radio receiver. Using the connected transmitters, you can switch connected ohmic and complex loads (such as incandescent lamps, low voltage halogen lamps) using the relay switch insert.
Inclusion Information
Triple click on operating surface.
Exclusion Information
Triple click on operating surface.
General Usage Information
Channels
The following table summarises the channels available for the 50x4xx -:
| Channel Name | Channel ID | Channel Type | Category | Item Type |
|---|---|---|---|---|
| Switch | switch_binary | switch_binary | Switch | Switch |
Switch
Switch the power on and off.
The switch_binary channel is of type switch_binary and supports the Switch item and is in the Switch category.
Device Configuration
The device has no configuration parameters defined.
Association Groups
Association groups allow the device to send unsolicited reports to the controller, or other devices in the network. Using association groups can allow you to eliminate polling, providing instant feedback of a device state change without unnecessary network traffic.
The 50x4xx supports 2 association groups.
Group 1: Switching additional devices
Switching additional radio receivers Switching additional radio receivers
Association group 1 supports 1 node.
Group 2: unknown
unknown unknown, not mentioned in the manual
Association group 2 supports 1 node.
Technical Information
Endpoints
Endpoint 0
| Command Class | Comment |
|---|---|
| COMMAND_CLASS_NO_OPERATION_V1 | |
| COMMAND_CLASS_BASIC_V1 | |
| COMMAND_CLASS_SWITCH_BINARY_V1 | |
| COMMAND_CLASS_SWITCH_ALL_V1 | |
| COMMAND_CLASS_SWITCH_TOGGLE_BINARY_V1 | |
| COMMAND_CLASS_CONFIGURATION_V1 | |
| COMMAND_CLASS_MANUFACTURER_SPECIFIC_V1 | |
| COMMAND_CLASS_PROTECTION_V2 | |
| COMMAND_CLASS_ASSOCIATION_V1 | |
| COMMAND_CLASS_VERSION_V1 | |
| COMMAND_CLASS_MULTI_CHANNEL_ASSOCIATION_V1 |
Documentation Links
Did you spot an error in the above definition or want to improve the content? You can contribute to the database here.