---
layout: documentation
title: 50x4xx - ZWave
---

{% include base.html %}

# 50x4xx Switch Sensor Cover
This describes the Z-Wave device *50x4xx*, manufactured by *Merten* with the thing type UID of ```merten_50x4xx_00_000```.

The device is in the category of *Wall Switch*, defining Any device attached to the wall that controls a binary status of something, for ex. a light switch.

![50x4xx product image](https://opensmarthouse.org/zwavedatabase/1414/image/)


The 50x4xx supports routing. This allows the device to communicate using other routing enabled devices as intermediate routers.  This device is also able to participate in the routing of data between other devices in the mesh network.

## Overview

The sensor cover contains a radio receiver. Using the connected transmitters, you can switch connected ohmic and complex loads (such as incandescent lamps, low voltage halogen lamps) using the relay switch insert.

### Inclusion Information

Triple click on operating surface.

### Exclusion Information

Triple click on operating surface.

### General Usage Information



## Channels

The following table summarises the channels available for the 50x4xx -:

| Channel Name | Channel ID | Channel Type | Category | Item Type |
|--------------|------------|--------------|----------|-----------|
| Switch | switch_binary | switch_binary | Switch | Switch | 

### Switch
Switch the power on and off.

The ```switch_binary``` channel is of type ```switch_binary``` and supports the ```Switch``` item and is in the ```Switch``` category.



## Device Configuration

The device has no configuration parameters defined.

## Association Groups

Association groups allow the device to send unsolicited reports to the controller, or other devices in the network. Using association groups can allow you to eliminate polling, providing instant feedback of a device state change without unnecessary network traffic.

The 50x4xx supports 2 association groups.

### Group 1: Switching additional devices

Switching additional radio receivers
Switching additional radio receivers

Association group 1 supports 1 node.

### Group 2: unknown

unknown
unknown, not mentioned in the manual

Association group 2 supports 1 node.

## Technical Information

### Endpoints

#### Endpoint 0

| Command Class | Comment |
|---------------|---------|
| COMMAND_CLASS_NO_OPERATION_V1| |
| COMMAND_CLASS_BASIC_V1| |
| COMMAND_CLASS_SWITCH_BINARY_V1| |
| COMMAND_CLASS_SWITCH_ALL_V1| |
| COMMAND_CLASS_SWITCH_TOGGLE_BINARY_V1| |
| COMMAND_CLASS_CONFIGURATION_V1| |
| COMMAND_CLASS_MANUFACTURER_SPECIFIC_V1| |
| COMMAND_CLASS_PROTECTION_V2| |
| COMMAND_CLASS_ASSOCIATION_V1| |
| COMMAND_CLASS_VERSION_V1| |
| COMMAND_CLASS_MULTI_CHANNEL_ASSOCIATION_V1| |

### Documentation Links

* [Manual](https://opensmarthouse.org/zwavedatabase/1414/reference/5024xx_HW_DE.pdf)

---

Did you spot an error in the above definition or want to improve the content?
You can [contribute to the database here](https://opensmarthouse.org/zwavedatabase/1414).