7.6 KiB

Raw Permalink Blame History

layout	title
documentation	50x5xx - ZWave

{% include base.html %}

50x5xx Roller shutter push-button

This describes the Z-Wave device 50x5xx, manufactured by Merten with the thing type UID of merten_50x5xx_00_000.

The device is in the category of Blinds, defining Roller shutters, window blinds, etc..

The 50x5xx supports routing. This allows the device to communicate using other routing enabled devices as intermediate routers. This device is also able to participate in the routing of data between other devices in the mesh network.

Overview

The roller shutter push-button contains a radio receiver for the Merten CONNECT radio system. If you use the blind control inserts 580699 or 580698, you can operate the connected roller shutter drive remotely using a Merten CONNECT radio transmitter. You can also operate the roller shutters using the rocker on the roller shutter push-button.

You can use the Merten CONNECT radio button, the Merten CONNECT radio remote control or the Merten CONNECT radio central unit as the transmitter.

Inclusion Information

Program (transmits Node info frame)

Triple click on operating surface. Used for include/exclude the device by the primary

Exclusion Information

Reset to the factory settings; exclude

Triple click on operating surface. Used for include/exclude the device by the primary

Channels

The following table summarises the channels available for the 50x5xx -:

Channel	Channel Id	Category	Item Type
Blinds Control	blinds_control	Blinds	Rollershutter
Sensor (luminance)	sensor_luminance		Number
Dimmer 1	switch_dimmer1	DimmableLight	Dimmer
Sensor (luminance) 1	sensor_luminance1		Number
Dimmer 2	switch_dimmer2	DimmableLight	Dimmer

Blinds Control

Provides start / stop control of blinds.

The blinds_control channel supports the Rollershutter item and is in the Blinds category.

Sensor (luminance)

Indicates the current light reading.

The sensor_luminance channel supports the Number item. This is a read only channel so will only be updated following state changes from the device.

Dimmer 1

The brightness channel allows to control the brightness of a light. It is also possible to switch the light on and off.

The switch_dimmer1 channel supports the Dimmer item and is in the DimmableLight category.

Sensor (luminance) 1

Indicates the current light reading.

The sensor_luminance1 channel supports the Number item. This is a read only channel so will only be updated following state changes from the device.

Dimmer 2

The brightness channel allows to control the brightness of a light. It is also possible to switch the light on and off.

The switch_dimmer2 channel supports the Dimmer item and is in the DimmableLight category.

Device Configuration

The following table provides a summary of the 7 configuration parameters available in the 50x5xx. Detailed information on each parameter can be found in the sections below.

Param	Name	Description
0	Switching/dimming/shutters
4	Switching single-surface
176	Break (motor protection)	Changeover delay (motor protection) Input (0 - 255) * 0.1 s
177	Travel time UP, Byte 1	Input 1 (0 - 255)
178	Travel time UP, Byte 2	Input 2 (0 - 255)
179	Travel time DOWN, Byte 1	Input 1 (0 - 255)
180	Travel time DOWN, Byte 2	Input 2 (0 - 255)