Socket network interface tests were failing due to DICONNECTED event
being advertised, where GLOBAL_UP was expected. It turned out that
nanostack receives two events: APPL_EVENT_CONNECT and
APPL_BACKHAUL_INTERFACE_PHY_UP. The second attempt to connect obviously
returns errors, but it also causes events to be sent out to the
application. The second attempt should not take place in case the
bootstrap is already started.
I also fixed two reports being sent with DISCONNECT status, while they
are actually something else.
Set tasklet parameters before connecting to prevent the parameters to be set to 0.
The tasklet parameters are reset to 0 when wisun_tasklet_connect gets called,
thus those need to be set in the wisun_tasklet_configure_and_connect_to_network
before they are used. This is also done this way in other tasklets.
To get Wi-Sun mesh network working, also nanostack with Wi-Sun support
is needed. ws_empty_functions.c and ws_management_api.h are temporary
included here, so that wisun_tasklet will compiled without problems.
They will replaced with the official versions with next nanostack release.
mbed.h has 'using namespace mbed;', hence some of the files skip
adding required namespace to the code, it is always good to specify the
namespace around the elements in header and `using namespace` in
specific CPP files, instead of all
mbed.h was added in test, via greentea and utest header files. 'mbed.h' is removed
from header files and required header file and namespace is added to CPP/C files
Added check for valid interface ID to network scan timer start so that it
is not triggered after disconnect. Added variable for mac api so that it
is not tried to set again after re-connecting.
Removed main tasklet ID and used instead tasklet id. Added check
for valid interface ID to network scan timer start so that it
is not triggered after disconnect. Added small delay to re-connect
so that stack has time to send its status events to application
after disconnect.
Previously get_mac_address on a ThreadInterface returned the EUI-64
reported by the radio driver. This was required for commissioning, but
was inconsistent with other interfaces, and the API concept.
5.9.0 inadvertently changed this so that get_mac_address returned the
actual MAC address used by the radio, which is a hash result of the
EUI-64 for Thread.
The original "return the EUI-64" form was somewhat faulty, as
get_mac_address would not return the EUI-64 set by set_device_eui64() or
another mechanism before connect() was called.
Rather than revert to old behaviour, add a new API to get the device
EUI-64 to ThreadInterface, alongside the existing set API.
Make Nanostack an OnboardNetworkInterface, implementing
add_ethernet_interface so it can use EMAC drivers.
Can now be used via EthernetInterface, and be the system's default
network stack.
Legacy support for NanostackEthernetInterface retained. Some
restructuring of mesh interface code to fit into the
OnboardNetworkStack:::Interface system.
ns_event_loop_thread_start() is incorrectly used at connect() phase, the initial
setup is already done at init() phase and the eventloop thread is correctly initialized.
Also, the usage of ns_event_loop_thread_start() API should be behind MBED_CONF_NANOSTACK_HAL_EVENT_LOOP_DISPATCH_FROM_APPLICATION
flag as application can decide to use main thread for event loop, which will result in linker error for this API call in
case of ARMCC compiler.
Martin Kojtal
Michal Paszta
Jarno Lamsa
Brian Daniels
Mahesh Mahadevan
Kari Haapalehto
Antti Kauppila
Cruz Monrreal
Alastair D'Silva
Mel W
deepikabhavnani
Seppo Takalo
Mika Leppänen
Kevin Bracey
Yogesh Pande