UserAllocatedEvent provides mechanism for event posting and dispatching without
utilization of queue internal memory. UserAllocatedEvent embeds all underlying
event data and doesn't require any memory allocation while posting and dispatching.
All of these makes it cannot fail due to memory exhaustion while posting.
Without free-up of peripheral pins, peripheral pins of the same peripheral may
share by multiple ports after port iteration, and this peripheral may fail with
pin interference.
In Nuvoton, only new-design chips support GPIO input pull-high/pull-low modes.
Targets not supporting this feature are listed below:
- NUMAKER_PFM_NANO130
- NUMAKER_PFM_NUC472
- NUMAKER_PFM_M453
Fix logic error on replying NACK at the end of transfer.
This is also to fix FPGA CI test mbed_hal_fpga_ci_test_shield-i2c/
i2c - test single byte read i2c API.
Better IP initialization sequence:
1. Configure IP pins
2. Select IP clock source and then enable it
3. Reset the IP (SYS_ResetModule)
NOTE1: IP reset takes effect regardless of IP clock. So it doesn't matter if
IP clock enable is before IP reset.
NOTE2: Non-configured pins may disturb IP's state, so IP pinout first and then
IP reset.
NOTE3: IP reset at the end of IP initialization sequence can cover unexpected
situation.
By default CoAP will create a copy of the whole data to be passed to application and it keeps the backward compatibility.
If enabled, application must NOT free the payload when it gets the COAP_STATUS_PARSER_BLOCKWISE_MSG_RECEIVED status.
And application must call sn_coap_protocol_block_remove() instead.
This test requires total latency (tot = h/w + s/w) (wakeup from deepsleep) be
under 1ms. To check the issue, measure total latency on Nuvoton targets:
TARGET EXP(us) EXP+TOL(us) ACT(us)
NANO130 42000 43000 42939
NUC472 42000 43000 42236
M453 42000 43000 43274
M487 42000 43000 42877
M2351 42000 43000 43213
Checking h/w spec, h/w latency (wakeup time from normal power-down mode) on
M487/M2351 is just 1us (n/a on other targets). S/W latency plays the major
part here.
S/W latency relies on system performance. On Nuvoton targets, 'LPTICKER_DELAY_TICKS'
possibly complicates the test. Anyway, to pass the test, add extra 1ms latency
(deep-sleep-latency) in targets.json for Nuvoton targets.
On Nuvoton targets, lp_ticker_set_interrupt(...) needs around 3 lp-ticker
ticks to take effect. It may miss when current tick and match tick are very
close (see hal/LowPowerTickerWrapper.cpp). Enlarge LPTICKER_DELAY_TICKS to
4 from 3 to address this boundary case.
Maciej Bocianski
int_szyk
Martin Kojtal
Hugues Kamba
Olli-Pekka Puolitaival
Antti Kauppila
Chun-Chieh Li
Ryan Morse
Dustin Crossman
Lei Zhang
Hennadiy Kytsun
Jaeden Amero
jeromecoutant
Veijo Pesonen
Antti Yli-Tokola
Evelyne Donnaes
Laurent Meunier
Seppo Takalo