4.0 KiB
| layout | title |
|---|---|
| documentation | ZL7431 - ZWave |
{% include base.html %}
ZL7431 In Wall Relay Switch
This describes the Z-Wave device ZL7431, manufactured by Vision Security with the thing type UID of vision_zl7431_00_000.
The device is in the category of Wall Switch, defining Any device attached to the wall that controls a binary status of something, for ex. a light switch.
The ZL7431 supports routing. This allows the device to communicate using other routing enabled devices as intermediate routers. This device is also able to participate in the routing of data between other devices in the mesh network.
Overview
Vision ZL7431US In-wall 1 relay switch
Inclusion Information
- Turn on and turn off the wall switch that connects with ZL 7431 module 4 times to be included
- (or press the Program SW 4 times within 2 seconds to be included),
then LED shall stop flashing.
Exclusion Information
- Turn on and turn off the wall switch that connects with ZL 7431 module 4 times to be excluded
- (or press the Program SW 4 times within 2 seconds to be excluded),
then LED shall start flashing
Channels
The following table summarises the channels available for the ZL7431 -:
| Channel Name | Channel ID | Channel Type | Category | Item Type |
|---|---|---|---|---|
| Switch | switch_binary | switch_binary | Switch | Switch |
Switch
Switch the power on and off.
The switch_binary channel is of type switch_binary and supports the Switch item and is in the Switch category.
Device Configuration
The following table provides a summary of the 1 configuration parameters available in the ZL7431. Detailed information on each parameter can be found in the sections below.
| Param | Name | Description |
|---|---|---|
| 1 | Indicator Light | Indicator Light |
| Switch All Mode | Set the mode for the switch when receiving SWITCH ALL commands |
Parameter 1: Indicator Light
Indicator Light
The following option values may be configured -:
| Value | Description |
|---|---|
| 1 | without Indicator Light |
| 2 | with Indicator Light |
The manufacturer defined default value is 1 (without Indicator Light ).
This parameter has the configuration ID config_1_1 and is of type INTEGER.
Switch All Mode
Set the mode for the switch when receiving SWITCH ALL commands.
The following option values may be configured -:
| Value | Description |
|---|---|
| 0 | Exclude from All On and All Off groups |
| 1 | Include in All On group |
| 2 | Include in All Off group |
| 255 | Include in All On and All Off groups |
This parameter has the configuration ID switchall_mode and is of type INTEGER.
Association Groups
Association groups allow the device to send unsolicited reports to the controller, or other devices in the network. Using association groups can allow you to eliminate polling, providing instant feedback of a device state change without unnecessary network traffic.
The ZL7431 supports 1 association group.
Group 1: Update Controller
Association group 1 supports 5 nodes.
Technical Information
Endpoints
Endpoint 0
| Command Class | Comment |
|---|---|
| COMMAND_CLASS_NO_OPERATION_V1 | |
| COMMAND_CLASS_BASIC_V1 | |
| COMMAND_CLASS_SWITCH_BINARY_V1 | Linked to BASIC |
| COMMAND_CLASS_SWITCH_ALL_V1 | |
| COMMAND_CLASS_CONFIGURATION_V1 | |
| COMMAND_CLASS_MANUFACTURER_SPECIFIC_V1 | |
| COMMAND_CLASS_ASSOCIATION_V1 | |
| COMMAND_CLASS_VERSION_V1 |
Documentation Links
Did you spot an error in the above definition or want to improve the content? You can contribute to the database here.