4.0 KiB
| layout | title |
|---|---|
| documentation | GE Plug in Smart Switch - ZWave |
{% include base.html %}
GE Plug in Smart Switch GE Plug in Smart Switch Zwave Plus
This describes the Z-Wave device GE Plug in Smart Switch, manufactured by Jasco Products with the thing type UID of ge_gepluginsmartswitch_00_000.
The GE Plug in Smart Switch supports routing. This allows the device to communicate using other routing enabled devices as intermediate routers. This device is also able to participate in the routing of data between other devices in the mesh network.
Overview
No device information is provided in the database. Consider updating the database to improve the documentation.
Channels
The following table summarises the channels available for the GE Plug in Smart Switch -:
| Channel | Channel Id | Category | Item Type |
|---|---|---|---|
| Switch | switch_binary | Switch | Switch |
Switch
Switch the power on and off.
The switch_binary channel supports the Switch item and is in the Switch category.
Device Configuration
The following table provides a summary of the 1 configuration parameters available in the GE Plug in Smart Switch. Detailed information on each parameter can be found in the sections below.
| Param | Name | Description |
|---|---|---|
| 3 | LED light | control LED light behavior. Default is on when connected device is off |
| Switch All Mode | Set the mode for the switch when receiving SWITCH ALL commands |
Parameter 3: LED light
control LED light behavior. Default is on when connected device is off
The following option values may be configured -:
| Value | Description |
|---|---|
| 0 | reset to factory default |
| 1 | LED is on when connected device is on |
| 2 | LED is off at all times |
The manufacturer defined default value is 0 (reset to factory default).
This parameter has the configuration ID config_3_1_wo and is of type INTEGER.
This is a read only parameter.
This is a write only parameter.
Switch All Mode
Set the mode for the switch when receiving SWITCH ALL commands.
The following option values may be configured -:
| Value | Description |
|---|---|
| 0 | Exclude from All On and All Off groups |
| 1 | Include in All On group |
| 2 | Include in All Off group |
| 255 | Include in All On and All Off groups |
This parameter has the configuration ID switchall_mode and is of type INTEGER.
Association Groups
Association groups allow the device to send unsolicited reports to the controller, or other devices in the network. Using association groups can allow you to eliminate polling, providing instant feedback of a device state change without unnecessary network traffic.
The device does not support associations.
Technical Information
Endpoints
Endpoint 0
| Command Class | Comment |
|---|---|
| COMMAND_CLASS_NO_OPERATION_V1 | |
| COMMAND_CLASS_BASIC_V1 | |
| COMMAND_CLASS_SWITCH_BINARY_V1 | Linked to BASIC |
| COMMAND_CLASS_SWITCH_ALL_V1 | |
| COMMAND_CLASS_CRC_16_ENCAP_V1 | |
| COMMAND_CLASS_ASSOCIATION_GRP_INFO_V1 | |
| COMMAND_CLASS_DEVICE_RESET_LOCALLY_V1 | |
| COMMAND_CLASS_ZWAVEPLUS_INFO_V1 | |
| COMMAND_CLASS_CONFIGURATION_V1 | |
| COMMAND_CLASS_MANUFACTURER_SPECIFIC_V1 | |
| COMMAND_CLASS_POWERLEVEL_V1 | |
| COMMAND_CLASS_FIRMWARE_UPDATE_MD_V1 | |
| COMMAND_CLASS_ASSOCIATION_V2 | |
| COMMAND_CLASS_VERSION_V2 |
Documentation Links
Did you spot an error in the above definition or want to improve the content? You can contribute to the database here.