1) if we receive more than one __sync, previous handshake would consider
it as echo_count and try to decode the value. Now we skip superfluous __sync.
2) reduce the uart load produced by the test, as we are heavily running tests in
parallel and not one-to-one this update was required.
Allow tickers to specify their native frequency and number of bits.
This allows the conversion to happen in common code rather than in
each vendor's implementation.
In test_case_2x_callbacks two tickers are setup to repeatedly
reschedule each other. When these tickers are deleted this
rescheduling is still occurring and can lead to a deleted ticker
being scheduled.
When this happens the following error message is displayed:
Thread 0x0 error -6: Not allowed in ISR context
Note - this problem was not detected by CI since the test reported
the correct results back to the host test and only experienced this
error on tear down.
This problem can be reproduced on an nrf51 by first building the ticker
test with:
"mbed test -t GCC_ARM -m NRF51_DK -n tests-mbed_drivers-ticker
--compile -DMBED_TRAP_ERRORS_ENABLED=1
-DMBED_HEAP_STATS_ENABLED=1 -DMBED_STACK_STATS_ENABLED=1"
And then running testing with:
"mbed test -t GCC_ARM -m NRF51_DK -n tests-mbed_drivers-ticker --run"
This commit reverts commit c1c0f1ea57
because it causes nightly builds to fail. This is because extra tests
added in tests-mbed_drivers-ticker fail on some targets, such as the
KL46Z, MAX32625MBED, MAX32630FTHR, NCS36510, NRF51 and NRF52_DK.
Remove the direct use of the microsecond and low power ticker from
the tests. This enforces that sleep mode is properly locked when
using timers. Furthermore, this prepares the codebase for new ticker
changes which allow differing clock frequencies and timer bit widths.
The lp_ticker test overrides the default ticker handler for the
low power ticker. This stops all other low power TimerEvents in the
system, including the ones for tickless, from getting called. Because
of this devices with tickless enabled malfunction during this test.
This patch fixes this problem by passing all lp ticker events it did
not trigger on to the TimerEvent irq handler.
Increase the Timeout period from 1ms to 10ms so interrupt latency has
1/10th the effect on the measurement. This prevents failures due to
interrupt latency causing a drift.
In case the target supports a page size of 1 byte, i.e. is able to
program flash 1 byte at a time, which is the case of STM32 F4 targets,
there is no reason for flash_device.program to return an error when
trying to write on an "unaligned" address.
Jimmy Brisson
Przemyslaw Stekiel
Martin Kojtal
Shrikant Tudavekar
Russ Butler
Seppo Takalo
Sarah Marsh
Deepika
Maciej Bocianski
Shrikant Tudavekar
Anna Bridge
Russ Butler
Laurent MEUNIER