For keep supporting external APIs with the same name (supposedly there are a larger
number of users of those APIs), BufferedSerial and ATParser are being renamed.
BufferedSerial becomes UARTSerial, will complement a future USBSerial etc.
ATParser becomes ATCmdParser.
* UARTSerial moves to /drivers
* APN_db.h is moved from platform to cellular/util/.
* Original CellularInterface is restored for backward compatability (again, supposedly there
are users of that).
* A new file, CellularBase is added which will now servce as the base class for all
upcoming drivers.
* Special restructuring for the driver has been undertaken. This makes a clear cut distinction
between an on-board or an off-board implementation.
- PPPCellularInterface is a generic network interface that works with a generic FileHandle
and PPP. A derived class is needed to pass that FileHandle.
- PPPCellularInterface provides some base functionality like network registration, AT setup,
PPP connection etc. Lower level job is delegated to the derived classes and various modem
specific APIs are provided which are supposed to be overridden.
- UARTCellularInterface is derived from PPPCellularInterface. It constructs a FileHandle and
passes it back to PPPCellularInterface as well as provides modem hangupf functionality.
In future we could proive a USBInterface that would derive from PPPCellularInterface and could
pass the FileHandle back.
- OnboardCellularInterface is derived from UARTCellularInterfae and provides hooks to
the target provided implementation of onbard_modem_api.h. An off-board modem, i.e, a modem on
a shield has to override the modem_init(), modem_power_up() etc as it cannot use
onboard_modem_api.h.
* Implements CellularInterface
* Reference design for CellularInterface implementations
* Uses an external mbed-os IP stack and talks to modem over PPP.
This provides a HAL layer for Modem bearing devices.
Provides a standard interface to upper layer drivers.
Platform providers will be implementing this API under their
specific targets.
As a reference, two implementations are provided under TARGET_C027 (UBLOX)
and TARGET_MTS_DRAGONFLY_F411RE (MultiTech).
targets.json now contains a tag "MODEM" which tells that this target
has a modem and the modem_api is protected by a flag DEVICE_MODEM
(following the DEVICE_SERIAL fashion ).
* Lays down ground for mbed modem_api
* Standardizes pin names relating to modem device for UBLOX C027 and MTS_DRAGONFLY_F411RE
devices
* Ublox modem api is changed to use a standard, platform independent name so that same
api could be used with multiple ubloc modems.
* DCD Polarity macro is added to assist the driver in knowing correct polarity
If you are using Ethernet, and not SPI Arduino pins:
=> keep your board with the default configuration
If you are using SPI Arduino pins, and not Ethernet:
=> you should remove the JP6 bridge on the front side of the board
If you need SPI Arduino and Ethernet:
=> you have to patch the NUCLEO board on the back side: set solder bridge SB121 to off, and SB122 to on
=> D11 is no more connected to PA_7 but to PB_5
=> overwrite d11_configuration config value in json file
Sam Grove
Steven Cooreman
kl-cruz
Andreas Larsson
Mahadevan Mahesh
Laurent MEUNIER
Anna Bridge
Yuguo Zou
Jimmy Brisson
Hasnain Virk
Martin Kojtal
Leon Lindenfelser
Bartek Szatkowski
Russ Butler
Matthias L. Jugel
Yoshihiro TSUBOI
Brian Daniels
jeromecoutant