-Check pointer before writing to it. It allows application to ask
only some of the stagger values.
-Change type of data_amount in get_stagger_estimate_to_address to be
uint16_t.
Add getsockopt options NSAPI_LATENCY and NSAPI_STAGGER to read
network specific timing constraints from socket.
-NS_LATENCY returns estimated latency to given address.
-NSAPI_STAGGER returns estimated initial delay that application
should wait before transmitting data to network.
Application can use the new options to avoid network congestion by
adjusting transmission delays and retry timeouts.
'received' was declared as an int but populated by cyhal_spi_transfer
after being cast to to (uint8_t *), which left the upper 3 bytes
uninitialized. Instead, declare as uint8_t and let the compiler upcast
the value when it is returned.
Earlier if mbed-trace was disabled but debug-at enabled, some AT trace codes were still
enabled causing unnecessary code size increase.
This commit fixes the issue that AT debug trace code is enabled only when both
mbed-trace.enable and cellular.debug-at are enabled.
Reduces binary size by about ~340bytes when mbed-trace is disabled but debug-at enabled.
All MBED_SPM targets have been removed previously, via commits
5cc66282dd ("PSOC6: remove PSA targets") and 115b09aba43b ("psoc6:
Remove FUTURE_SEQUANA and FUTURE_SEQUANA_M0"). Remove all the dead
MBED_SPM code, as no targets use it.
Signed-off-by: Jaeden Amero <jaeden.amero@arm.com>
Some non-Mbed-OS, pre-existing CMSIS-RTOSv2 applications depend on
CMSIS-RTOSv2 Automatic Dynamic Allocation, also known as Object-specific
memory pools. Mbed OS doesn't by default provide any memory to the
CMSIS-RTOSv2 Automatic Dynamic Allocation pool, as doing so would waste
memory if the feature is not used; even if the feature is used, as a
platform, Mbed OS can't know how many objects of which types will be
created by an application and therefore will either waste memory or not
provide enough memory in a hard to debug manner. Portable CMSIS-RTOSv2
applications depending on CMSIS-RTOSv2 Automatic Dynamic Allocation
should instead configure the memory pools themselves, as applications
know best their memory requirements.
Add Mbed configuration options which can be used by applications to
control the amounts of memory available to the CMSIS-RTOSv2 Automatic
Dynamic Allocation subsystem. This enables portable CMSIS-RTOSv2
applications, which can run on any CMSIS-RTOSv2 OS, to be able to run on
Mbed OS as well.
RTX's configuration options for CMSIS-RTOSv2 memory are documented at
http://www.keil.com/pack/doc/CMSIS_Dev/RTOS2/html/config_rtx5.html
Signed-off-by: Devaraj Ranganna <devaraj.ranganna@arm.com>
Signed-off-by: Jaeden Amero <jaeden.amero@arm.com>
The Nordic SoftDevice BLE stack used by NRF51* targets only
supports legacy BLE APIs which we will removed completely.
Note: NRF52* targets which use Cordio BLE stack are unaffected.
The current Maxim BLE driver only implements the old BLE API
which is deprecated and will be removed soon. Once an updated
BLE stack for Maxim becomes available, BLE feature can be
re-enabled.
Martin Kojtal
Arto Kinnunen
Deepak Shreshti
Kyle Kearney
Kimmo Vaisanen
Jaeden Amero
Rajkumar Kanagaraj
Hugues Kamba
Devaraj Ranganna
Lingkai Dong
Gabor Abonyi
Chun-Chieh Li
jeromecoutant