---
layout: documentation
title: EBV-105 - ZWave
---

{% include base.html %}

# EBV-105 Wireless Water Shutoff Valve
This describes the Z-Wave device *EBV-105*, manufactured by *EcoNet Controls* with the thing type UID of ```econet_ebv105_00_000```.

The device is in the category of *Valve*, defining Valves used to control water or gas. e.g. a flow stop valve..

![EBV-105 product image](https://opensmarthouse.org/zwavedatabase/271/image/)


The EBV-105 supports routing. This allows the device to communicate using other routing enabled devices as intermediate routers.  This device is also able to participate in the routing of data between other devices in the mesh network.

## Overview

Wireless z-wave water shutoff controller, prevent water damage. 

The EBV105 water shutoff controller is easy to install and configure. No special tools or plumbing required. The included clamp supports installation.

You need to add a water leak sensor.

### Inclusion Information

Place the Z-Wave controller in pairing (learning) mode. Press the SET/Power button 3 or more times rapidly (within 0.5 seconds).

### Exclusion Information

Place your Z-Wave controller in exclusion (un-learning) mode. Once the controller is in exclusion mode, bring the EBV105 close to the Z-Wave controller (several feet) and press the Power button 3 or more time rapidly (within 0.5 seconds).

## Channels

The following table summarises the channels available for the EBV-105 -:

| Channel Name | Channel ID | Channel Type | Category | Item Type |
|--------------|------------|--------------|----------|-----------|
| Switch | switch_binary | switch_binary | Switch | Switch | 

### Switch
Switch the power on and off.

The ```switch_binary``` channel is of type ```switch_binary``` and supports the ```Switch``` item and is in the ```Switch``` category.



## Device Configuration

The device has no configuration parameters defined.

## Association Groups

Association groups allow the device to send unsolicited reports to the controller, or other devices in the network. Using association groups can allow you to eliminate polling, providing instant feedback of a device state change without unnecessary network traffic.

The EBV-105 supports 1 association group.

### Group 1: Group 1


Association group 1 supports 5 nodes.

## Technical Information

### Endpoints

#### Endpoint 0

| Command Class | Comment |
|---------------|---------|
| COMMAND_CLASS_NO_OPERATION_V1| |
| COMMAND_CLASS_BASIC_V1| |
| COMMAND_CLASS_SWITCH_BINARY_V1| Linked to BASIC|
| COMMAND_CLASS_SWITCH_ALL_V1| |
| COMMAND_CLASS_MANUFACTURER_SPECIFIC_V1| |
| COMMAND_CLASS_ASSOCIATION_V1| |
| COMMAND_CLASS_VERSION_V1| |

### Documentation Links

* [Quick Start Guide](https://opensmarthouse.org/zwavedatabase/271/reference/EBV105-Z-Valve-Quick-Start-Guide-M2.pdf)

---

Did you spot an error in the above definition or want to improve the content?
You can [contribute to the database here](https://opensmarthouse.org/zwavedatabase/271).