---
layout: documentation
title: DZR15 - ZWave
---

{% include base.html %}

# DZR15 Scene Capable Receptacle
This describes the Z-Wave device *DZR15*, manufactured by *Leviton* with the thing type UID of ```leviton_dzr15_00_000```.

The device is in the category of *Wall Switch*, defining Any device attached to the wall that controls a binary status of something, for ex. a light switch.

![DZR15 product image](https://opensmarthouse.org/zwavedatabase/200/image/)


The DZR15 supports routing. This allows the device to communicate using other routing enabled devices as intermediate routers.  This device is also able to participate in the routing of data between other devices in the mesh network.

## Overview

Z-Wave Enabled 15 Amp Scene Capable Receptacle with LED Locator - White/Light Almond

The wireless Leviton DZR15 is a Z-Wave enabled 15A tamper resistant receptacle designed for use for most residential lighting and motor applications. A large range of load types are supported including incandescent, halogen and magnetic low voltage, electronic low voltage, fluorescent, and motor loads up to ½ horse power.

### Inclusion Information

Press and hold the button on the outlet for 7 seconds until the light starts blinking amber.

## Channels

The following table summarises the channels available for the DZR15 -:

| Channel Name | Channel ID | Channel Type | Category | Item Type |
|--------------|------------|--------------|----------|-----------|
| Switch | switch_binary | switch_binary | Switch | Switch | 
| Scene Number | scene_number | scene_number |  | Number | 

### Switch
Switch the power on and off.

The ```switch_binary``` channel is of type ```switch_binary``` and supports the ```Switch``` item and is in the ```Switch``` category.

### Scene Number
Triggers when a scene button is pressed.

The ```scene_number``` channel is of type ```scene_number``` and supports the ```Number``` item.



## Device Configuration

The device has no configuration parameters defined.

## Association Groups

Association groups allow the device to send unsolicited reports to the controller, or other devices in the network. Using association groups can allow you to eliminate polling, providing instant feedback of a device state change without unnecessary network traffic.

The device does not support associations.
## Technical Information

### Endpoints

#### Endpoint 0

| Command Class | Comment |
|---------------|---------|
| COMMAND_CLASS_NO_OPERATION_V1| |
| COMMAND_CLASS_BASIC_V1| |
| COMMAND_CLASS_SWITCH_BINARY_V1| |
| COMMAND_CLASS_SWITCH_ALL_V1| |
| COMMAND_CLASS_SCENE_ACTIVATION_V1| |
| COMMAND_CLASS_SCENE_ACTUATOR_CONF_V1| |
| COMMAND_CLASS_MANUFACTURER_SPECIFIC_V1| |
| COMMAND_CLASS_POWERLEVEL_V1| |
| COMMAND_CLASS_NODE_NAMING_V1| |
| COMMAND_CLASS_VERSION_V1| |
| COMMAND_CLASS_MANUFACTURER_PROPRIETARY_V1| |

### Documentation Links

* [Product spec](https://opensmarthouse.org/zwavedatabase/200/reference/DZR15-Tsht-BW-v1p4.pdf)

---

Did you spot an error in the above definition or want to improve the content?
You can [contribute to the database here](https://opensmarthouse.org/zwavedatabase/200).