60 lines
2.1 KiB
YAML
60 lines
2.1 KiB
YAML
persistent_notification:
|
|
create:
|
|
description: Show a notification in the frontend
|
|
|
|
fields:
|
|
message:
|
|
description: Message body of the notification. [Templates accepted]
|
|
example: Please check your configuration.yaml.
|
|
|
|
title:
|
|
description: Optional title for your notification. [Optional, Templates accepted]
|
|
example: Test notification
|
|
|
|
notification_id:
|
|
description: Target ID of the notification, will replace a notification with the same Id. [Optional]
|
|
example: 1234
|
|
|
|
homematic:
|
|
virtualkey:
|
|
description: Press a virtual key from CCU/Homegear or simulate keypress
|
|
|
|
fields:
|
|
address:
|
|
description: Address of homematic device or BidCoS-RF for virtual remote
|
|
example: BidCoS-RF
|
|
|
|
channel:
|
|
description: Channel for calling a keypress
|
|
example: 1
|
|
|
|
param:
|
|
description: Event to send i.e. PRESS_LONG, PRESS_SHORT
|
|
example: PRESS_LONG
|
|
|
|
zwave:
|
|
start_network:
|
|
description: Start the zwave network. This might take a while, depending on how big your zwave network is.
|
|
|
|
stop_network:
|
|
description: Stop the zwave network, all updates into HASS will stop.
|
|
|
|
heal_network:
|
|
description: Start a zwave network heal. This might take a while and will slow down the zwave network greatly while it is being processed. Refer to OZW.log for details.
|
|
|
|
add_node:
|
|
description: Add a new node to the zwave network. Refer to OZW.log for details.
|
|
|
|
add_node_secure:
|
|
description: Add a new node to the zwave network with secure communications. Node must support this, and network key must be set. Refer to OZW.log for details.
|
|
|
|
remove_node:
|
|
description: Remove a node from the zwave network. Refer to OZW.log for details.
|
|
|
|
test_network:
|
|
description: This will send test to nodes in the zwave network. This will greatly slow down the zwave network while it is being processed. Refer to OZW.log for details.
|
|
|
|
soft_reset:
|
|
description: This will reset the controller without removing its data. Use carefully because not all controllers support this. Refer to controllers manual.
|
|
|