{
  "config": {
    "step": {
      "user": {
        "title": "Subaru Starlink Configuration",
        "description": "Please enter your MySubaru credentials\nNOTE: Initial setup may take up to 30 seconds",
        "data": {
          "username": "[%key:common::config_flow::data::username%]",
          "password": "[%key:common::config_flow::data::password%]",
          "country": "Select country"
        }
      },
      "two_factor": {
        "title": "Subaru Starlink Configuration",
        "description": "Two factor authentication required",
        "data": {
          "contact_method": "Please select a contact method:"
        }
      },
      "two_factor_validate": {
        "title": "Subaru Starlink Configuration",
        "description": "Please enter validation code received",
        "data": {
          "validation_code": "Validation code"
        }
      },
      "pin": {
        "title": "Subaru Starlink Configuration",
        "description": "Please enter your MySubaru PIN\nNOTE: All vehicles in account must have the same PIN",
        "data": {
          "pin": "PIN"
        }
      }
    },
    "error": {
      "cannot_connect": "[%key:common::config_flow::error::cannot_connect%]",
      "invalid_auth": "[%key:common::config_flow::error::invalid_auth%]",
      "incorrect_pin": "Incorrect PIN",
      "bad_pin_format": "PIN should be 4 digits",
      "two_factor_request_failed": "Request for 2FA code failed, please try again",
      "bad_validation_code_format": "Validation code should be 6 digits",
      "incorrect_validation_code": "Incorrect validation code"
    },
    "abort": {
      "already_configured": "[%key:common::config_flow::abort::already_configured_account%]",
      "cannot_connect": "[%key:common::config_flow::error::cannot_connect%]"
    }
  },

  "options": {
    "step": {
      "init": {
        "title": "Subaru Starlink Options",
        "description": "When enabled, vehicle polling will send a remote command to your vehicle every 2 hours to obtain new sensor data. Without vehicle polling, new sensor data is only received when the vehicle automatically pushes data (normally after engine shutdown).",
        "data": {
          "update_enabled": "Enable vehicle polling"
        }
      }
    }
  }
}