mbed-os/targets/TARGET_ublox/TARGET_HI2110/objects.h

74 lines
1.7 KiB
C

/* mbed Microcontroller Library
* Copyright (c) 2016 u-blox
*
* Licensed under the Apache License, Version 2.0 (the "License");
* you may not use this file except in compliance with the License.
* You may obtain a copy of the License at
*
* http://www.apache.org/licenses/LICENSE-2.0
*
* Unless required by applicable law or agreed to in writing, software
* distributed under the License is distributed on an "AS IS" BASIS,
* WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
* See the License for the specific language governing permissions and
* limitations under the License.
*/
#ifndef MBED_OBJECTS_H
#define MBED_OBJECTS_H
#include "cmsis.h"
#include "PortNames.h"
#include "PeripheralNames.h"
#include "PinNames.h"
#include "stdbool.h"
#ifdef __cplusplus
extern "C" {
#endif
typedef enum {
IRQ_NOT_SET,
IRQ_ON,
IRQ_OFF
} irq_setting_t;
struct port_s {
__IO uint32_t *reg_dir;
__IO uint32_t *reg_out;
__IO uint32_t *reg_val;
__IO uint32_t *reg_drv;
PortName port;
uint32_t mask;
};
struct gpio_irq_s {
/* Don't bother with having a port number here as there's only one */
uint32_t ch; /* Corresponds to the interrupt pin */
};
struct serial_s {
SerialConfig config;
PinName rx_pin;
PinName tx_pin;
volatile uart_ctrl_t *reg_base;
uint8_t index;
uint32_t baud_rate;
bool format_set; /* If true then the struct that follows is populated */
struct {
uint8_t stop_bits;
uint8_t data_bits;
uint8_t parity;
} format;
irq_setting_t irq_rx_setting;
irq_setting_t irq_tx_setting;
};
#include "gpio_object.h"
#ifdef __cplusplus
}
#endif
#endif