mbed-os/targets/TARGET_ARM_SSG/TARGET_CM3DS_MPS2/rtc_api.c

79 lines
1.7 KiB
C

/*
* Copyright (c) 2017 ARM Limited
*
* Licensed under the Apache License, Version 2.0 (the "License");
* you may not use this file except in compliance with the License.
* You may obtain a copy of the License at
*
* http://www.apache.org/licenses/LICENSE-2.0
*
* Unless required by applicable law or agreed to in writing, software
* distributed under the License is distributed on an "AS IS" BASIS,
* WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
* See the License for the specific language governing permissions and
* limitations under the License.
*/
#include "rtc_api.h"
#include "device.h"
#include "cmsis.h"
/**
* \defgroup hal_rtc RTC hal functions
* @{
*/
/**
* \brief Initialize the RTC peripheral.
* The RTC starts counting from 0x0 at reset and increments
* with a frequency of 1hz (clock source: CLK1HZ).
* The current value can be read through the DATA register
*/
void rtc_init(void)
{
CMSDK_RTC->RTCCR |= (1 << CMSDK_RTC_ENABLE_Pos);
}
/**
* \brief Deinitialize the RTC peripheral
* According to DDI0224B_RTC_PL031_TRM.pdf chapter 3.3.4 there is
* no reason to implement.
*/
void rtc_free(void)
{
/* Not supported */
}
/**
* \brief Get the RTC enable status
*
* \return 0 disabled, 1 enabled
*/
int rtc_isenabled(void)
{
return (CMSDK_RTC->RTCCR & CMSDK_RTC_ENABLE_Msk);
}
/**
* \brief Get the current time from the RTC peripheral
*
* \return The current time in seconds
*/
time_t rtc_read(void)
{
return (time_t)CMSDK_RTC->RTCDR;
}
/**
* \brief Set the current time to the RTC peripheral, write it to LOAD register
*
* \param[in] t The current time to be set in seconds
*/
void rtc_write(time_t t)
{
CMSDK_RTC->RTCLR = (uint32_t)t;
}
/**@}*/