mirror of https://github.com/ARMmbed/mbed-os.git
57 lines
2.2 KiB
CMake
57 lines
2.2 KiB
CMake
# Mbed OS upload method configuration file for target NUCLEO_F446RE.
|
|
# To change any of these parameters from their default values, set them in your build script between where you
|
|
# include app.cmake and where you add mbed os as a subdirectory.
|
|
|
|
# Notes:
|
|
# 1. Using the JLINK upload method with your dev board requires converting its ST-LINK into a J-Link. See here for details: https://www.segger.com/products/debug-probes/j-link/models/other-j-links/st-link-on-board/
|
|
|
|
# General config parameters
|
|
# -------------------------------------------------------------
|
|
set(UPLOAD_METHOD_DEFAULT MBED)
|
|
|
|
# Config options for MBED
|
|
# -------------------------------------------------------------
|
|
|
|
set(MBED_UPLOAD_ENABLED TRUE)
|
|
set(MBED_RESET_BAUDRATE 115200)
|
|
|
|
# Config options for JLINK
|
|
# -------------------------------------------------------------
|
|
|
|
set(JLINK_UPLOAD_ENABLED TRUE)
|
|
set(JLINK_CPU_NAME STM32F446RE)
|
|
set(JLINK_CLOCK_SPEED 4000)
|
|
set(JLINK_UPLOAD_INTERFACE SWD)
|
|
|
|
# Config options for PYOCD
|
|
# -------------------------------------------------------------
|
|
# If your target is not natively supported by the pyOCD, then you need install a keil package for family of your target by hands.
|
|
# Type "pyocd pack show" to console and you will see a list of already installed packages.
|
|
# If any package for your family is not on the list, then you need install them via command "pyocd pack install stm32f4".
|
|
# Then just type "pyocd pack find STM32f4" or "pyocd pack find STM32f446" or "pyocd pack find STM32f446RE" and you will see the part name of your target.
|
|
|
|
set(PYOCD_UPLOAD_ENABLED TRUE)
|
|
set(PYOCD_TARGET_NAME STM32F446RETx)
|
|
set(PYOCD_CLOCK_SPEED 4000k)
|
|
|
|
# Config options for OPENOCD
|
|
# -------------------------------------------------------------
|
|
|
|
set(OPENOCD_UPLOAD_ENABLED TRUE)
|
|
set(OPENOCD_CHIP_CONFIG_COMMANDS
|
|
-f ${OpenOCD_SCRIPT_DIR}/board/st_nucleo_f4.cfg)
|
|
|
|
# Config options for STM32Cube
|
|
# -------------------------------------------------------------
|
|
|
|
set(STM32CUBE_UPLOAD_ENABLED TRUE)
|
|
set(STM32CUBE_CONNECT_COMMAND -c port=SWD reset=HWrst)
|
|
set(STM32CUBE_GDBSERVER_ARGS --swd)
|
|
|
|
# Config options for stlink
|
|
# -------------------------------------------------------------
|
|
|
|
set(STLINK_UPLOAD_ENABLED TRUE)
|
|
set(STLINK_LOAD_ADDRESS 0x8000000)
|
|
set(STLINK_ARGS --connect-under-reset)
|