mbed-os/components/802.15.4_RF/atmel-rf-driver/atmel-rf-driver/NanostackRfPhyAtmel.h

132 lines
3.6 KiB
C++

/*
* Copyright (c) 2014-2015 ARM Limited. All rights reserved.
* SPDX-License-Identifier: Apache-2.0
* Licensed under the Apache License, Version 2.0 (the License); you may
* not use this file except in compliance with the License.
* You may obtain a copy of the License at
*
* http://www.apache.org/licenses/LICENSE-2.0
*
* Unless required by applicable law or agreed to in writing, software
* distributed under the License is distributed on an AS IS BASIS, WITHOUT
* WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
* See the License for the specific language governing permissions and
* limitations under the License.
*/
#ifndef NANOSTACK_RF_PHY_ATMEL_H_
#define NANOSTACK_RF_PHY_ATMEL_H_
#include "at24mac.h"
#include "PinNames.h"
#if defined(MBED_CONF_NANOSTACK_CONFIGURATION) && DEVICE_SPI && DEVICE_I2C && defined(MBED_CONF_RTOS_PRESENT)
#include "NanostackRfPhy.h"
// Uncomment to use testing gpios attached to TX/RX processes
// #define TEST_GPIOS_ENABLED
// Arduino pin defaults for convenience
#if !defined(ATMEL_SPI_MOSI)
#define ATMEL_SPI_MOSI D11
#endif
#if !defined(ATMEL_SPI_MISO)
#define ATMEL_SPI_MISO D12
#endif
#if !defined(ATMEL_SPI_SCLK)
#define ATMEL_SPI_SCLK D13
#endif
#if !defined(ATMEL_SPI_CS)
#define ATMEL_SPI_CS D10
#endif
#if !defined(ATMEL_SPI_RST)
#define ATMEL_SPI_RST D5
#endif
#if !defined(ATMEL_SPI_SLP)
#define ATMEL_SPI_SLP D7
#endif
#if !defined(ATMEL_SPI_IRQ)
#define ATMEL_SPI_IRQ D9
#endif
#if !defined(ATMEL_I2C_SDA)
#define ATMEL_I2C_SDA D14
#endif
#if !defined(ATMEL_I2C_SCL)
#define ATMEL_I2C_SCL D15
#endif
#if !defined(TEST_PIN_TX)
#define TEST_PIN_TX D6
#endif
#if !defined(TEST_PIN_RX)
#define TEST_PIN_RX D3
#endif
#if !defined(TEST_PIN_CSMA)
#define TEST_PIN_CSMA D4
#endif
#if !defined(TEST_PIN_SPARE_1)
#define TEST_PIN_SPARE_1 D2
#endif
#if !defined(TEST_PIN_SPARE_2)
#define TEST_PIN_SPARE_2 D8
#endif
class RFBits;
class TestPins;
class NanostackRfPhyAtmel : public NanostackRfPhy {
public:
NanostackRfPhyAtmel(PinName spi_mosi, PinName spi_miso,
PinName spi_sclk, PinName spi_cs, PinName spi_rst, PinName spi_slp, PinName spi_irq,
PinName i2c_sda, PinName i2c_scl);
virtual ~NanostackRfPhyAtmel();
virtual int8_t rf_register();
virtual void rf_unregister();
virtual void get_mac_address(uint8_t *mac);
virtual void set_mac_address(uint8_t *mac);
private:
AT24Mac _mac;
uint8_t _mac_addr[8];
RFBits *_rf;
TestPins *_test_pins;
bool _mac_set;
const PinName _spi_mosi;
const PinName _spi_miso;
const PinName _spi_sclk;
const PinName _spi_cs;
const PinName _spi_rst;
const PinName _spi_slp;
const PinName _spi_irq;
};
#ifdef TEST_GPIOS_ENABLED
#define TEST_TX_STARTED test_pins->TEST1 = 1;
#define TEST_TX_DONE test_pins->TEST1 = 0;
#define TEST_RX_STARTED test_pins->TEST2 = 1;
#define TEST_RX_DONE test_pins->TEST2 = 0;
#define TEST_CSMA_STARTED test_pins->TEST3 = 1;
#define TEST_CSMA_DONE test_pins->TEST3 = 0;
#define TEST_SPARE_1_ON test_pins->TEST4 = 1;
#define TEST_SPARE_1_OFF test_pins->TEST4 = 0;
#define TEST_SPARE_2_ON test_pins->TEST5 = 1;
#define TEST_SPARE_2_OFF test_pins->TEST5 = 0;
extern void (*fhss_uc_switch)(void);
extern void (*fhss_bc_switch)(void);
#else
#define TEST_TX_STARTED
#define TEST_TX_DONE
#define TEST_RX_STARTED
#define TEST_RX_DONE
#define TEST_CSMA_STARTED
#define TEST_CSMA_DONE
#define TEST_SPARE_1_ON
#define TEST_SPARE_1_OFF
#define TEST_SPARE_2_ON
#define TEST_SPARE_2_OFF
#endif //TEST_GPIOS_ENABLED
#endif /* MBED_CONF_NANOSTACK_CONFIGURATION */
#endif /* NANOSTACK_RF_PHY_ATMEL_H_ */