{
    "name": "stm32wl-lora-driver",
    "requires": ["lora"],
    "config": {
        "buffer-size": {
            "help": "Max. buffer size the radio can handle, Default: 255 B",
            "value": 255
        },
        "boost-rx": {
            "help": "Increases sensitivity at the cost of power ~2mA for around ~3dB in sensitivity 0 = disabled, 1 = enabled",
            "value": 0
        },
        "regulator-mode": {
            "help": "Default: DCDC (low power, high BOM). Alternatively, LDO = 0. USE_LDO = 0, USE_DCDC = 1",
            "value": "USE_DCDC"
        },
        "sleep-mode": {
            "help": "Default: Warm start = 0, Cold start = 1",
            "value": 0
        },
        "standby-mode": {
            "help": "Default: STDBY_RC = 0, STDBY_XOSC = 1",
            "value": "STDBY_RC"
        },
        "crystal_select": {
            "help": "Default: Internal XO = 0, IS_TCXO_SUPPORTED = 1",
            "value": "IS_TCXO_SUPPORTED"
        },
        "tcxo_ctrl": {
            "help": "TCXO Control voltage. Default: TCXO control TCXO_CTRL_1_7V (RAK3172SIP use TCXO_CTRL_3_0V)",
            "value": "TCXO_CTRL_1_7V"
        },
        "rf_switch_config": {
            "help": "Default: RBI_CONF_RFO_LP_HP = 0, RBI_CONF_RFO_LP = 1, RBI_CONF_RFO_HP = 2",
            "value": "RBI_CONF_RFO_LP_HP"
        },
        "rf_rfo_hp_lpfix": {
            "help": "Fix high power consumption when only RFO_HP is used on some boards. No fix = 0, Fix = 1",
            "value": 1
        },
        "rf_wakeup_time": {
            "help": "Radio maximum wakeup time (in ms)",
            "value": 10
        },
        "rf-switch-ctl1": {
            "value": "NC"
        },
        "rf-switch-ctl2": {
            "value": "NC"
        },
        "rf-switch-ctl3": {
            "value": "NC"
        },
        "debug_rx": {
            "help": "GPIO pin for RX debug"
        },
        "debug_tx": {
            "help": "GPIO pin for TX debug"
        },
        "debug_invert": {
            "help": "invert levels of the debug_rx and debug_tx pins. Default: 0 standard, 1 invert",
            "value" : 0
        }
    },
    "target_overrides": {
        "NUCLEO_WL55JC": {
            "rf-switch-ctl1": "PC_4",
            "rf-switch-ctl2": "PC_5",
            "rf-switch-ctl3": "PC_3"
        }
    }
}