Only one point of attention:
STM_MODE_ANALOG_ADC_CONTROL is a specific mode that is only supported on L4.
So STM_MODE_ANALOG_ADC_CONTROL was moved to index 13 (last entry)
of gpio_mode table so that all the other modes are common and only the last
one is specific.
Let's make the code more common for gpios.
The only difference between STM32 families is that BRR register may
not be available. In case BRR is not available, we use the 16 left bits
of BSRR instead. We could always use BSRR, but BRR saves one left-shift
operation, so let's use it when available.
By default we will consider using BRR, except for platforms that define
GPIO_IP_WITHOUT_BRR.
- RCC init: unused clock was enabled without any init parameters
- RCC init: one PLL parameter was missing
- ADC: a parameter setting was missing to init clock
- GPIO: mode was not allowed by ST HAL API
- ll_utils: compilation issue
Even when HSE is used, it is possible to get a 32MHz system clock
8MHz x PLLMUL=12 % PLLDIV=2 = 32MHz
And we still get 48MHz USB clock:
8MHz x PLLMUL=12 % 2 = 48MHz
This allows to take full benefit of the CPU capability.
Since most of the code in i2c_api.c is now relying on STM32 HAL, there
is now a possibility to make a common usage of this code accross families.
The IP version definition is introduced per family, to allow a switch of
functionnalities, especially the frequency management which differs.
BTw, we fix the F0 frequency settings at the same time.
F1 is managed for now as an exception as the HAL API for sequential transmit
/receive is not yet available (coming soon)
This applies the same fix as was done for F4 to solve issue #2638.
The fix applies ell to all other families excpet STM32F1.
Basically, to avoid over-writing the pull-up/-down settings, we read the
current state from HW.
the SPI_ASYNCH feature has been already activated for STM32F4.
This patchset makes it supported on all STM32 families by:
- moving spi_s structure at family level instead of board level
- using the F4 spi_api.c reference implementation and making it a common
stm_spi_api.c file which makes maintenance a lot easier.
- the only part that needs to be implemented for each family is the computation
of the clock frequency input to the spi peripheral which is not the same
accross families. So this is what remains in the spi_api.c of each family.
Because of the introduction of the common file, all the above modifications
needs to be done at once.
Supported toolchains initialization steps have been modified to make sure
that mbed_sdk_initi is called _after_ RAM initialization and _before_ C++
objects creation.
since this was done, there is no need to redundant SystemCoreClockUpdates
in the drivers
Various toolchains supported in MBED don't follow the same initialization
steps. This can have impacts on platform behavior.
For STM32, it is needed to call the HAL_Init() _after_ the RAM has been
initialized (sdata from flash / zero initialized data) and _before_ the C++
objects are being created, especially if those objects require support
of tickers for instance.
In GCC, this is easily done because SystemInit is called after the ram
initialisation, so HAL_Init does not need to called from mbed_sdk_init.
this is covered by the changes in mbed_overrides.c files.
This series should solve issue reported here:
STM32 (At least F401) breaks if Tickers are activated in a global object #2115
Laurent MEUNIER
Martin Kojtal
jeromecoutant
adustm
bcostm
Michel Jaouen
Sam Grove
Brian Daniels
Laurent MEUNIER
Christopher Haster