Return value was ignored, and TDBStore:init() ended up in a
MBED_ERROR() phase after that.
TDBStore API was limited to allow returning of only two separate
errors, which may end up hiding the actual return value. Change
the documentation slightly to allow returning of original error
code from the underlying block device.
Fixes#11591
_ongoing_tx_msg was incorrectly initialized before _mlme_confirmation.
Fixes following build warning:
[Warning] LoRaMac.h@691,26: 'LoRaMac::_ongoing_tx_msg' will be initialized after [-Wreorder]
[Warning] LoRaMac.h@689,28: 'loramac_mlme_confirm_t LoRaMac::_mlme_confirmation' [-Wreorder]
[Warning] LoRaMac.cpp@68,1: when initialized here [-Wreorder]
Reasons to remove TRNG support:
1. M252 just has 32KiB SRAM and cannot afford mbedtls application.
2. Implementing TRNG HAL with PRNG H/W has security concern.
Without free-up of peripheral pins, peripheral pins of the same peripheral may
share by multiple ports after port iteration, and this peripheral may fail with
pin interference.
In Nuvoton, only new-design chips support GPIO input pull-high/pull-low modes.
Targets not supporting this feature are listed below:
- NUMAKER_PFM_NANO130
- NUMAKER_PFM_NUC472
- NUMAKER_PFM_M453
Fix logic error on replying NACK at the end of transfer.
This is also to fix FPGA CI test mbed_hal_fpga_ci_test_shield-i2c/
i2c - test single byte read i2c API.
Better IP initialization sequence:
1. Configure IP pins
2. Select IP clock source and then enable it
3. Reset the IP (SYS_ResetModule)
NOTE1: IP reset takes effect regardless of IP clock. So it doesn't matter if
IP clock enable is before IP reset.
NOTE2: Non-configured pins may disturb IP's state, so IP pinout first and then
IP reset.
NOTE3: IP reset at the end of IP initialization sequence can cover unexpected
situation.
On Nuvoton targets, lp_ticker_set_interrupt(...) needs around 3 lp-ticker
ticks to take effect. It may miss when current tick and match tick are very
close (see hal/LowPowerTickerWrapper.cpp). Enlarge LPTICKER_DELAY_TICKS to
4 from 3 to address this boundary case.
Without this override, mpu hal will require 5 mpu regions which exceed 4 mpu
regions supported by M252 (see hal/mpu/mbed_mpu_v8m.c). In this scenario,
we will hit assert error but we actually meet stack overrun first due to just
0x400 bytes for emitting error message. The issue doesn’t occur on other
targets such as M487 because it has 8 mpu regions.
Martin Kojtal
Antti Kauppila
Mirela Chirica
Seppo Takalo
Filip Jagodzinski
Kimmo Vaisanen
Marc Emmers
Ladislas de Toldi
Ryan Morse
Anna Bridge
Qinghao Shi
Dominika Maziec
Chun-Chieh Li