IPV6 and IPV6V4 support is also network dependent not only modem.
Having these properties enabled for a modem requires a fallback
mechanism during PDP context activation. This mechanism is missing
at the moment and that can result in imposibility to establish
succesfull connection when network only supports IPV4 contexts.
Deprecate wait() in favour of acquire(), try_acquire(),
try_acquire_for() and try_acquire_until().
Brings Semaphore more into line with CMSIS-RTOS 2 (which uses "acquire"),
itself (as it has "release"), and other classes having "try", "try for"
and "try until".
Also steps away from vague "wait" term - the primary operation here is
to acquire the semaphore, and this will of course sleep.
This modem is a special case. It uses a given socket ID value rather
than providing one. A naive solution here would be to directly map the
index of a CellularSocket object in the CellularSocket container. But
considering the case where there are multiple sockets being opened (some
sockets being already created at the modem and some yet not created), direct mapping
to indices will not work. As it can happen that the CellularSocket
object is allocated but the socket id is not assigned yet as it is not
actually created on the modem.
In such a case, we check the container and assign the socket id from the
pool if an empty slot was found.
Disconnect was sent to all CellularContext classes even it concerned
one specific context. Some disconnect events are still sent to all
context classes. These event are coming from network and ment for all
context classes or event did not specify cid.
CellularDevice::get_default_instance() is a weak method and is overriden
by either a default construction provided in the code or by application
at some stage. This method needs to be flagged otherwise using another
driver will be hindered by the default overriding of this driver.
For default construction of the driver, it would be necessary to define
the pins. However as we don't know the correct pins, until/unless user
sets them up for us. So it makes sense to mark the pins as NC. It would
be easier to debug if the pins are set to NC if user forgot to set them
up.
To make this driver more useful, we needed to do some changes. The
wirings for the modem can differ on the board so we also need to be
flexible in our approach.
It is now mandatory to provide the power pin and pin polarity in the
constructor alongwith the file handle. Reset pin is optional.
Standard 3GPP TS27.007 states that the AT+CGSN command can optionally
have type parameter that determines the output. However Quiectel EC2X
series doesn't accept parameters. We need to reflect that in the
cellular properties setup.
Provides basic power up / power down sequences for Quectel EC2X series
modems. Can be used in PPP mode. For using the on-board IP stack, we
will need to add and implement classes that provide context.
Driver constructor takes power and reset control pins along with the
FileHandle. A default construction is provided which can be chosen by
the application in its mbed_app.json. Otherwise the user is free to
construct as per demand.
Ari Parkkila
Martin Kojtal
Mirela Chirica
Pekka Pesu
Kevin Bracey
Hasnain Virk
Daniel Lee
Anna Bridge
Kimmo Vaisanen
kevin.ong
Teppo Järvelin
Martin Kojtal
Sarah Marsh
Teemu Kultala
mudassar-ublox
Cruz Monrreal