When doing so, do not disbale GPIO clocks as they may be used by other
drivers !
As a result, debug will be disabled by default, but can be enabled by
either modifying code or selecting MBED debug profile.
Issue was seen when running BLE_GAP example from
mbed-os-example-ble.
In STM32WB, the M0 core cannot be reset except if the whole target
is reset. So in case of re-initialization of the BLE stack, the
transport layer should not be initialized again. The HCI reset
command will do the job.
These files are not BLE specific, but also needed for some clock setting
for instance.
In order to compile an MBED2 application, we need to move the files.
- move hw_conf.h file to targets/TARGET_STM/TARGET_STM32WB directory as
this is used also out of BLE feature.
- create a dedicated hal_deepsleep function as the behavior in WB is a lot
different from other existing STM32 targets
- update clock tree configuration to directly clock the entire tree @ 32MHz
out of HSE. This is needed as we want to let the M0 core running without
any change on M0-side of clocks when M4 enters /exits deep sleep.
Laurent Meunier
bcostm